Posted on February 7, 2025, 4:12 pm By admin
Thickness: 1.25 (31.75mm). Vehicle Bolt Pattern: 6×5.5(6×139.7mm). Wheel Bolt Pattern: 6×5.5(6×139.7mm). Center Bore: 78.1mm. Stud/Nut Thread Pitch: M14x1.5. Positions your wheels 1.25 inches outward. Allows installation of wider wheels & tires. Increases your vehicle’s track-width. Hydraulic Pre-Pressed Studs eliminate the risk of vibrations. Improves the look of your vehicle. Following your vehicle owner’s manual, proper raise the vehicle and support it using adequately load-rated jackstands. Remove wheels and inspect rotors for any damage or cracks. If any damage is identified, don’t continue with this installation. Remove any wheel visible rust from the mating flange on the vehicle’s rotor. Check both the rotor and wheel mounting flanges for burns, rivet heads, or other obstruction which could prevent proper seating of the spacer/adapter. If proper seating can be achieved, apply provided thread locker to vehicle’s studs and mount the wheel spacers on to rotor by torquing provided wheel spacers/adapter lug nuts. Tighten all lug nuts to the appropriate torque specification using a torque wrench. Install wheel on to wheel spacer using existing lug nuts. DO NOT USE AN IMPACT WRENCH. Check that wheel and tire clearance allow for full steering(lock-to-lock). If there is no interference, vehicle may be lowered.
Categories: hubcentric Tags: 6x55, chevy, hubcentric, sierra, silverado, spacers, wheel